Fiat 500X Owner's Handbook Manual page 126

REPLACING AN
EXTERNAL BULB
Dipped/main beam
headlights
To replace the bulb, proceed as follows:
❒ working from inside the engine
compartment, remove rubber cap A fig.
106, using the dedicated tab;
106
❒ turn the bulb-bulb holder assembly
anticlockwise and then remove it sliding
it outwards;
❒ disconnect the electrical connector B
and replace the bulb C.
❒ then insert the bulb and bulb holder
assembly in its housing and turn it
clockwise, making sure that it is locked
correctly;
❒ refit the rubber cap A.
124
IMPORTANT Only replace the bulb
when the engine is off. Also ensure that
the engine is cold, to prevent the risk
of burns.
Xenon gas discharge main
beam/dipped beam
headlights
For replacing these bulbs, contact a
Fiat Dealership.
Side lights/daytime running
lights (DRL)
To replace the bulbs proceed as
follows:
F1B0146C
107
❒ steer the vehicle wheels completely
inwards;
❒ undo screws A fig. 107 using the
screwdriver provided and remove
inspection flap B;
❒ identify the bulb for the side
light/DRL;
108
❒ turn the bulb-bulb holder assembly
anticlockwise and then remove it sliding
it outwards;
❒ replace the "bayonet-fitted" bulb A
fig. 108;
❒ finally, refit inspection flap B fig. 107,
completely tightening fixing screws A.
Front direction indicators
To replace the bulbs proceed as
follows:
❒ steer the vehicle wheels completely
inwards;
F1B0147
❒ undo screws A fig. 107 using the
screwdriver provided and remove
inspection flap B;
❒ identify the direction indicator bulb;
❒ turn the bulb-bulb holder assembly
anticlockwise and then remove it sliding
it outwards;
❒ replace the "bayonet-fitted" bulb A
fig. 108;
F1B0148C