Installing the KVM Switch and Application Servers
The optional KVM switch and application servers must be installed in an IT-style rack (front/rear
mounting rails).
!
Important:
If a KVM switch is used, the application servers must be installed close enough to
Important:
the CS700/CS780 for the KVM cables to reach.
If chassis slides are included, please refer to the instructions included with the slides.
Note:
A keyboard/mouse "Y" cable is required to connect the KVM to the embedded
Note:
CRS. The CS700/CS780 CPU does not require a mouse.
Before installing, unpack and verify the physical condition of the KVM switch and application
servers. Contact audio web conferencing support if any discrepancies are found.
Connecting the System
!
Important:
DO NOT connect power to the system until all hardware has been mounted to
Important:
racks or otherwise placed in service locations.
Power Connections
CS700 AC Power
The CS700 uses dual AC power feeds. For redundant operation, connect each cord to a
separate circuit. Avaya recommends the use of uninterruptible power supplies (UPS) for each
AC feed.
Installing the KVM Switch and Application Servers
Issue 1 July 2006
39