Chapter 2: Installing CS700/CS780 Hardware
This chapter describes hardware installation procedures.
Installation consists of the following steps:
1. Verify installation of power, thermal management, LAN, and network connections.
2. Verify receipt of necessary hardware and cables.
3. Mount hardware to racks as specified.
4. Connect power, keyboard/video/mouse, modems, LAN, and network connections.
5. Verify system operation.
6. Notify Support Help Desk that the system is ready to be configured. Note any discrepancies
between installed facilities and the Site Survey.
Steps 1 and 2 were covered in
6.
Before You Begin
You should have a working knowledge of teleconferencing concepts, customer requirements,
telecommunication protocols (TCP/IP, VOIP/SIP), and UNIX commands.
Electrostatic Discharge (ESD) Precautions
If the replacement of any system board is required, you must adhere to industry-standard ESD
precautions.
When repairing equipment in the field, the minimum equipment necessary for ESD protection is:
Anti-static conductive mat with grounding cable.
●
Wrist strap with grounding cable.
●
ESD protective storage bags or other suitable containers.
●
"Chapter 1: Getting
Started." This chapter covers steps 3 through
Issue 1 July 2006
25