NEC Express5800 Series Maintenance Manual page 92

Chapter 2 Configuring and Upgrading the System
Member
device name" format as the number of the member. "F" is checked on the left side of the device name for
the member out of the redundancy configuration in case of an abnormality. In this case, repair is required.
92
The information of the member that forms RAID is displayed in the "(Slot number)
Member information
Upper 2 digits of 6
digits at the head
2 digits at the middle
of 6 digits at the head
Lower 2 digits of 6
digits at the head
-part<X>
Important
Do not pull out/insert the hard disk drive or stop/restart the system while each RAID
device status is "RESYNC", "RECOVERY", "CHECK" or "REPAIR". Wait until each
status changes to "DUPLEX".
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
Meaning
10 means the disk installed to the CPU/IO module 0, while
11 means the disk installed to the CPU/IO module 1.
Fixed as "40".
Indicates the value +1 of the hardware slot number. (Any
value among "01" to "08")
Partition number inside the disk.
1. Hard Disk Drive Duplexing