NEC Express5800 Series Maintenance Manual page 58

Chapter 1 Maintenance
(2)
Error messages on a virtual LCD
In EXPRESSSCOPE Engine 3 web browser window, you can confirm virtual LCD error messages. For details
on the virtual LCD, refer to "EXPRESSSCOPE Engine 3 User's Guide".
The table below shows the error messages displayed on upper and lower lines, cause, and solution.
Messages displayed on an upper LCD line
Message
on Upper LCD Line
XXXX BIOSXXXX
POST Completed
Successfully
POST ERROR
XXXX
System Simplex
System Duplex
CPU Broken
IO Broken
58
Description
Displayed while POST is running.
Displayed when POST completes normally.
Error XXXX was detected during POST.
The system is operating in simplex mode.
CPU/IO module is operating in duplex
mode.
A CPU failure was detected.
An I/O unit failure was detected.
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
Message displayed on
upper LCD line
Message displayed on
lower LCD line
Solution
This is not an error.
This is not an error.
Check the message displayed on LCD, and take an
appropriate action.
This is not an error.
This is not an error.
Contact your sales representative.
Contact your sales representative.
6. Error Messages