Procedure In Ft Server Utility - NEC Express5800 Series Maintenance Manual

Chapter 1 Maintenance
4.1.3

Procedure in ft Server Utility

Use ft Server Utility menu and select the relevant component.
Perform the procedure below to start component.
1. Select the target component.
2. Check Current state of the target component by selecting Refresh.
3. Select Start button of the target component.
Perform the procedure below to stop the component.
1. Select the target component.
2. Check Current state of the target component by selecting Refresh.
3. Select Stop button of the target component.
Sample screen of ft Server Utility
26

Tips The target component starts after a while.

The start result can be verified by "State" of target component.
Note that state display is not refreshed automatically, you need to select Refresh to
check Current state.

Tips The target component stops after a while.

The stop result can be verified by "State" of target component.
Note that state display is not refreshed automatically, you need to select Refresh to
check Current state.
CPU module
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
4. Maintenance of the Server