Boot - NEC Express5800 Series Maintenance Manual

Chapter 3 Useful Features
1.2.5

Boot

If you move the cursor to Boot, the Boot menu where you can configure the boot order appears.
For details about the options, see the table below.
Option
Boot Configuration
Quiet Boot
Bootup NumLock State
Setup Prompt Timeout
Boot Mode
Boot Option Priorities
Boot Option #1
Boot Option #2
Boot Option #3
Boot Option #4
Parameter
–
Disabled
[Enabled]
On
[Off]
[0] - 65535
Legacy
[UEFI]
–
–
–
–
–
Express5800/R320e-E4, R320e-M4 Maintenance Guide (Linux)
Descriptions
–
Enable or disable the feature to display logo during
POST. When this option is set to Disabled, the results of
POST execution are displayed instead of the logo.
If BIOS Redirection Port is enabled, this option is
shown as Unavailable and inaccessible (run with
Disabled state automatically)
Enable or disable NumLock feature of keyboard.
Set a value from 0 to 65535 seconds that specifies the
F2 key input wait time required to start SETUP.
Set the boot mode..
If [Load Setup Defaults] in the Save & Exit mode was
executed, this option is set to [UEFI].
For this server, set this option to [UEFI].
Set this option to [Legacy] before physically formatting a
hard disk drive. After the formatting is done, set this
option to [UEFI] again.
–
These items display the priority of boot devices.
1. System BIOS
183