Dc Power Supply Specifications - Avaya Virtual Services Platform 7200 Series Installation Manual

DC power supply specifications

The VSP 7200 comes with one 800 W DC power supply and you can install a secondary power
supply for redundancy.
Important:
You must have either a power supply or a power supply cover in each bay to ensure proper
ventilation. Leaving a power supply bay unpopulated or uncovered impairs the ability of the fans
to cool the chassis.
Figure 3: DC power supply
The 800 W DC power supply uses a DC power supply wiring assembly to connect the power supply
to the DC power source.
The following table describes the regulatory DC power specifications for the VSP 7200 switch. Note
that regulatory power specifications are based on the maximum rated capacity of the power supplies
and are not based on typical power consumption, which is typically lower.
Table 7: DC power specifications
Input Current:
Input Voltage (rms):
Power Consumption:
Temperature:
Inrush Current:
Turn on Condition:
Important:
12 V output rise time, from 10 to 90 percent, must be the maximum of 70 ms and monotonic under all
defined input and output conditions.
Efficiency:
January 2015
VSP 7254XSQ or 7254XTQ
24–16 A
40.5 to 60 VDC
800 W maximum
Operating range: 0 to 50 ºC
Non-operating range: -40 to 70 ºC
50 A maximum
500 ms maximum after application of DC power
• 88% minimum at 100% load level
• 92% minimum at 50% load level
• 88% minimum at 20% load level
• 80% minimum at 10% load level
Installation Job Aid for Avaya Virtual Services Platform 7200 Series
13