Ac Power Supply Specifications - Avaya Virtual Services Platform 7200 Series Installation Manual

2. Slide the power supply into the slot.
3. Verify that the power supply is fully seated in the slot. The spring latch should engage and
return to its original position.
Note:
The chassis design prevents an incorrect installation of a power supply. If you insert a
power supply upside down, it will not fully insert.
4. Once you install a power supply, you can connect the AC power cord to the power supply on
the back of the switch, and then connect the cord to an AC power outlet.
Important:
The VSP 7200 does not have an AC power switch. When you connect the power cord to
a power supply and connect the cord to an AC power outlet, the switch powers up
immediately.
Warning:
Disconnecting the AC power cord is the only way to turn off AC power to the VSP 7200.
Allow at least 30 seconds for the VSP 7200 to fully power down before restoring power.
Otherwise, the VSP 7200 might produce a core file during the reset leading to an extra
delay during boot time. Always connect the AC power cord in a location that is quickly
and safely accessible in case of an emergency.
5. Check the LED on the bottom right side of the power supply. Solid green indicates that
power is operating normally. If it's off, check the connections.
Important:
You can hot swap power supplies while the switch is operational. One power supply is
required for continued switch operation.

AC power supply specifications

The VSP 7254XSQ comes with an 460 W AC power supply and you can install a secondary power
supply for redundancy.
January 2015 Installation Job Aid for Avaya Virtual Services Platform 7200 Series
6