Connecting Cables - TANDBERG 6000 MXP Profile User Manual

2.2 Connecting Cables

All cables needed in standard configuration are already connected to the codec. Connect these
cables to their respective parts of the system.
1. Power cables
Connect the power cable to an electrical distribution socket.
2. Monitor cables
Connect the DVI cable to the input on your monitor.
3. Microphone cables
Connect the microphone cable to the microphones.
4. Camera cable
Connect the camera cable labeled "Main Cam" to the S-Video connector on the camera. Connect
also the control cable labeled "Camera Control" between the RJ-45 on the camera, and the
Dataport 2 on the codec.
5. PC cable
Connect the PC cable to the PC.
6a. ISDN cables - using BRI interface
Connect the ISDN cables to the ISDN sockets (S/T interface) provided by the network provider.
The main ISDN number will be that number associated with the socket to which ISDN cable
number 1 has been connected.
Note! The system does not have a built-in network terminator. If wall socket provides an
ISDN U-interface, an NT1 between your system and the ISDN line is needed, see
10 for more information.
6b. ISDN cable - using the PRI interface
If using the PRI interface, the E1/T1 cable should be connected to a CSU (Channel Service Unit).
). It is recommended that a CSU be used between the system and the PRI line from the network
provider, see Appendix
6c. Other networks - using the External Network interface
If using other networks, see
7. LAN cable
To connect the system to a Local Area Network (LAN), connect the cable labelled "LAN Ethernet"
to a suitable Ethernet port on the LAN.
8.
ISDN/External/Leased E1/T1 and Appendix 9.
Installation
Appendix
23