TANDBERG 6000 MXP Profile User Manual page 16

TANDBERG 6000 MXP Profile
Microphone
The high quality table microphone is designed to be placed on a table during a videoconference.
Up to three microphones can be connected. The ideal location for the microphone is on a flat
surface at least 2m (6.5 ft) from the front of the system. The system will automatically equalize
sound levels. Loud and soft voices are picked up and transmitted to the far end at approximately
the same level.
Digital Natural Audio Module (DNAM)
The Digital Natural Audio Module (DNAM) is designed to enhance the audio quality during a
videoconference. The DNAM provides natural sounding audio, as if the person or another sound
source in the conference is present in the same room as you.
The DNAM is a frequency-compensated sound system optimized for voice and other sounds that
appears in modern videoconferencing. It is designed and dedicated specifically for
videoconferencing requirements. The use of the highest quality speaker elements as well as
proper amplifier- and software techniques minimizes signal distortion. The monitor- or television
speakers are disabled, and the sound is completely handled by the DNAM. The system will
automatically detect the DNAM and optimize the audio output. Once detected the audio output
will be in digital format (S/PDIF). The DNAM supports both analog and digital input.
The DNAM amplifier is mounted below the speaker cabinet.
TANDBERG Tracker
The tracker is a small infrared remote control device made
to steer the camera to any desired location within the
room. Typically, several trackers would be used with each
system.
Each tracker has two buttons:

One Single person button to point the camera at a
specific person/location.

One Group button to point the camera at all
participants.
Beneath the battery in the tracker, there is a switch, which
can be set to 16 different positions between 0 and F. For
16