Connecting The Control - DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual

164
Fig. 81: Establishing equipotential bonding
①
(1) - Control connection
To establish equipotential bonding:
1. Tilt the machine head.
2. Feed the equipotential bonding cable from the connection (1)
on the rear side of the control through the slot in the tabletop
and fix it in place at the connection of the base plate (2).

7.13.2 Connecting the control

DANGER
Risk of death from live components!
Unprotected contact with electricity can result
in serious injuries or death.
Disconnect the power plug before connecting
the control. Ensure the power plug cannot be
unintentionally reinserted.
To connect the control:
1. Connect the control as specified in the wiring diagram
( p. 197).
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
(2) - Base plate connection
Setup
②