Removing A Bay Panel; Replacing A Bay Panel - IBM Aptiva Series Handbook

Removing a bay panel

To remove a plastic bay panel:
1.
Remove the system unit cover. Refer to "Opening the
system unit" on page 6-4 for instructions.
2.
Press the latch on the inner right side of a bay panel
and pull it out about an inch. This step releases the
right side of the panel.
You may need to temporarily remove the bay panel
Note:
above the panel you are removing.
7-6 Chapter 7: Adding and removing adapter cards and drives
3.
Use both hands to pull the bay panel and remove it
completely from the system unit cover.
Be careful when performing the above step to avoid
Caution: breaking the latches and tabs on the bay panel. DO
NOT force the panel out.

Replacing a bay panel

To replace a bay panel in front of an empty drive bay:
1.
Fit the left side of the bay panel (the side with the
angle) to the left edge of the system unit cover,
aligning the panel latches with the groove on the side
of the cover.
2.
Push the bay panel in until the latch on its inner right
side locks the panel into place.