IBM Aptiva Series Handbook page 131

Hide thumbs Also See for Aptiva Series:
Table of Contents

Advertisement

Table 4: Error codes and messages (Continued)
Error codes
Error messages
186
Onboard ECP Parallel Port DMA
Conflict(s)
187
Onboard Floppy Drive DMA Conflict(s)
188
Onboard Floppy Drive I/O Address
Conflict(s)
189
Onboard IDE Secondary Channel I/O
Address Conflict(s)
190
Onboard Serial Port I/O Address
Conflict(s)
192
Onboard Parallel Port I/O Address
Conflict(s)
Note:
If any of the errors persist after performing the listed corrective actions, see "Chapter 2: HelpWare support and services" on
page 2-1 for information on obtaining service.
Corrective actions
1. Remove all the add-on cards in the system.
2. Power on the system to see if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, replace the cards.
1. Remove all the add-on cards in the system.
2. Power on the system to see if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, replace the cards.
1. Remove all the add-on cards in the system.
2. Power on the system to see if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, replace the cards.
1. Remove all the add-on cards in the system.
2. Power on the system to see if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, enter Setup and
set the Reset Resource Assignments parameter to Yes, then
reboot the system.
5. If the problem persists, set the Onboard IDE Secondary
Channel parameter to Disabled, then reboot the system.
1. Enter Setup and change the onboard serial port I/O address or
disable it.
2. Reboot the system.
1. Enter Setup and change the onboard serial port I/O address or
disable it.
2. Reboot the system.
Error codes and messages
9-21

Advertisement

Table of Contents
loading

Table of Contents