IBM Aptiva Series Handbook page 130

Table 4: Error codes and messages (Continued)
Error codes Error messages
180 Onboard Serial Port IRQ Conflict(s)
182 Onboard Parallel Port IRQ Conflict(s)
183 Onboard Diskette Drive IRQ Conflict(s)
184 Onboard Pointing Device IRQ
Conflict(s)
185 Onboard IDE Secondary Channel IRQ
Conflict(s)
Note:
If any of the errors persist after performing the listed corrective actions, see "Chapter 2: HelpWare support and services" on
page 2-1 for information on obtaining service.
9-20 Chapter 9: Diagnosing and recovering from problems
Corrective actions
1. Remove all the add-on cards in the system.
2. Power on the system to see if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, replace the cards.
1. Remove all the add-on cards in the system.
2. Power on the system to see if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, replace the cards.
1. Remove all the add-on cards in the system.
2. Power on the system to check if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, replace the cards.
1. Remove all the add-on cards in the system.
2. Power on the system to check if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, replace the cards.
1. Remove all the add-on cards in the system.
2. Power on the system to see if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, enter Setup and
set the Reset Resource Assignments parameter to Yes, then
reboot the system.
5. If the problem persists, set the Onboard IDE Secondary
Channel parameter to Disabled, then reboot the system.