IBM Aptiva Series Handbook page 132

Table 4: Error codes and messages (Continued)
Error codes Error messages
193 Onboard Serial Port Conflict(s)
195 Onboard Parallel Port Conflict(s)
196 Onboard IDE Primary Channel IRQ
Conflict(s)
197 Onboard IDE Primary Channel I/O
Conflict(s)
198 PnP ISA Card(s) Disabled
Note:
If any of the errors persist after performing the listed corrective actions, see "Chapter 2: HelpWare support and services" on
page 2-1 for information on obtaining service.
9-22 Chapter 9: Diagnosing and recovering from problems
Corrective actions
Enter Setup and change the onboard serial port I/O address or
change the add-on card serial port I/O address, then reboot the
system.
Enter Setup and change the onboard parallel port I/O address or
change the add-on card parallel port I/O address, then reboot the
system.
1. Remove all the add-on cards in the system.
2. Power on the system to see if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, enter Setup and
set the Reset Resource Assignments parameter to Yes, then
reboot the system.
5. If the problem persists, set the Onboard IDE Primary Channel
parameter to Disabled, then reboot the system.
1. Remove all the add-on cards in the system.
2. Power on the system to see if it works without the cards.
3. Re-install the cards one by one to determine which of the cards
caused the error.
4. After determining the defective card or cards, enter Setup and
set the Reset Resource Assignments parameter to Yes, then
reboot the system.
5. If the problem persists, set the Onboard IDE Primary Channel
parameter to Disabled, then reboot the system.
1. Enter Setup and set the Reset Resource Assignments to Yes,
then reboot the system.
2. If the error message reappears, determine which onboard
device is least necessary and disable it under the Devices and I/
O Ports menu in Setup.