Current Version Verification - HP 9000 Series Service Manual

Support Information

Current Version Verification

With On-line Diagnostics
The current revision of Firmware can be determined using on-line diagnostics. If on-line diagnostics
are not present on your system, use the BOOT CONSOLE HANDLER procedure to verify the current
revision.
Refer to the appropriate on-line diagnostic procedure to determine the version of firmware presently
installed on your system.
Procedure A
For HP-UX systems prior to 10.20
1. At the system prompt, enter "sysdiag"
2. At the DUI prompt, enter "sysmap"
3. At the ENTER MAP prompt, enter "cpumap"
4. Note the PDC Firmware value
5. At the ENTER MAP prompt, enter "exit"
6. At the DUI prompt, enter "exit"
Determine the Support Tools Manager version
To determine the Support Tools Manager version proceed as follows.
For HP-UX systems with 10.20 and later, it is necessary to determine the Support Tools Manager
Version which will, in turn, indicate which procedure to follow.
1. Login as root
2. At the prompt, enter 'mstm'
3. Note the Support Tools Manager Version
For Version A.07.00 or less, continue with Procedure B
For Version A.08.00 and later, continue with Procedure C
Procedure B
Support Tools Manager version A.07.00 or less
1. Press f2 (ok)
2. Press f4 (device)
3. Press f5 (select class)
4. Move cursor to "Processor"
5. Press the 'enter' key on the keyboard
Appendix B B-41