Table 6-8 Memory Subsystem Codes - HP 9000 Series Service Manual

Major Code Category 7: Memory Subsystem Faults
and PDCE_HPMC Memory Faults

Table 6-8 Memory Subsystem Codes

Ostat Code
FLT 7000
FLT 7001
FLT 7002
FLT 7003
FLT 7004
FLT 7005
FLT 7006
FLT 7007
FLT 7008
FLT 7009
FLT 70FF
FLT 7FFF
FLT 7101
FLT 7102
FLT 7103
FLT 7104
FLT 7105
FLT 7106
FLT 7107
FLT 7200
FLT 7210
FLT 7220
FLT 7230
FLT 7301
FLT 7302
FLT 7303
Chapter 6
D270/D370, D280/D380/R380 and D390/R390 Front Panel LCD Codes
HPMC in the memory system
Icache parity fault in memory test
Dcache parity fault in memory test
MSI read time-out (usually caused by reading beyond the end of memory)
MSI write time-out (usually caused by writing beyond the end of memory)
Processor/Memory bus parity fault
Write bomb fault (Processor/Memory bus parity detected on incoming data)
Memory address ECC fault
Multi-bit memory fault
Single bit memory fault
Unknown HPMC
Catastrophic memory fault
Master Memory Controller not responding
Master Memory Controller not ready fault
Master Memory Controller failed to clear
Master Memory Controller sticky bits
Master Memory Controller bad revision
Master Memory Controller register selftest fault
Master Memory Controller fault in ECC test
No Slave Memory Controller available
Slave Memory Controller failed
Bad Slave Memory Controller revision
Slave Memory Controller failed to respond
SIMM 0 bytes are not equal
SIMM 1 bytes are not equal
SIMM 0 data and SIMM 1 data have a mismatch error
Description
6- 13