Maintenance; General Notes; Cleaning With Cleaning Brushes - Buderus Logano GE315 Installation And Maintenance Instructions Manual

6

Maintenance

6 Maintenance
6.1

General notes

Important for energy saving!
Please ensure your boiler and burner is checked
and maintained annually by a heating engineer.
We recommend that you take a Service contract
to ensure this is done regularly. Failure to
maintain the boiler will lead to higher fuel cost,
possible breakdown reduced service life.
You can obtain special cleaning brushes from
your local Buderus dealer.
6.2

Cleaning with cleaning brushes

Disconnect your heating system from the mains
electricity supply.
NOTE!
e.g. activate the emergency stop switch for
your heating system outside your boiler
room and secure against unintentional
switching on.
Switch the On/Off switch (Fig. 49, Item 1) on the
control unit to "0" (OFF).
Isolate the main fuel valve.
ATTENTION!
Work on fuel lines MUST only be
perfomed by registered engineers [In
the UK engineers must be CORGI or
OFTEC registered] .
Slightly raise the front wall and remove forward
(Fig. 50).
Loosen the four screws securing the burner door on
the front sections (see chapter "2.6.3 Burner door
installation", page 20).
Open the burner door.
40
Fig. 52
Fig. 53
We reserve the right to make any changes due to technical modifications.
Installation and maintenance instructions Logano GE315 • Issue 02/2006
Example: Logamatic 4000 Series control unit
Remove the front wall
1