Network Settings Page Definitions; Network Settings/Ethernet Settings - Grandstream Networks GXV3380 Administration Manual

Multicast Paging H.264
Payload Type
Multicast Listening

Priority

Listening Address

Label

Network Settings Page Definitions

Network Settings/Ethernet Settings

Preferred Internet
Protocol
Different Networks for
Data and VoIP Calls
IPv4
IPv4 Address Type
DHCP VLAN Override
DHCP Host name
(Option 12)
Vendor Class ID
(Option 60)
IP Address
Note: Lower profile is easier to decode, while higher profile has higher
compress rate. Usually, use Baseline profile for low CPU Performance
device, and choose high profile for video conference.
Determines the H.264 codec payload type for the multicast paging call.
The default setting is "99".
Configures the IP address and port number for monitoring multicast paging
call. When the initiator initiates a call, answer the call and display listening
address and tag of the monitoring target. This feature supports Video
Multicast, when the initiator initiates Video Multicast, it will automatically
add the number 2 on the port of the listening address. Reboot the phone
to make changes take effect.
The valid IP address range is from 224.0.0.0 to 239.255.255.255. Users
may also fill the label for each listening address corresponding to priority.
If IPv4 is selected, the phone will be using IPv4 addressing, otherwise, it
will be using IPv6 addressing. Default is "IPv4 Only".
Configures whether to set up different networks for the phone data and the
call. If set to "Yes", you need to configure the data network and VoIP
network respectively.
Configures the appropriate network settings on the phone. Users could
select from "DHCP", "Static IP" or "PPPoE"(Point-to-point Protocol over
Ethernet). By default, it is set to "DHCP".
Selects the DHCP Option VLAN mode. When set to "DHCP Option 132
and DHCP option 133", the phone will get DHCP option 132 and 133 as
VLAN ID and VLAN priority. When set to "Encapsulated in DHCP Option
43", the phone will get values from Option 43 which encapsulate VLAN ID
and VLAN priority.
Note: Please make sure the "Allow DHCP Option 43 and Option 66 to
Override Server" setting under maintenanceupgrade is checked. The
default setting is " Encapsulated in DHCP Option 43 ".
Sets the name of the client in the DHCP request. It is optional but may be
required by some Internet Service Providers.
Configures the vendor class ID header in the DHCP request.
The default setting is Grandstream GXV3380.
Defines the phone's static IP address if the static IP is used.
GXV3380 Administration Guide
Version 1.0.1.19
P a g e | 64