Network Page Definitions - Grandstream Networks GRP26 Series Administration Manual

Provision
Total Number of Custom Ringtone
Update
Settings �� Multicast Paging
Multicast Paging Function
Allowed in DND Mode
Paging Barge
Paging Priority Active
Multicast Channel Number
Multicast Paging Codec
Multicast Sender ID
Multicast Listening

Network Page Definitions

Internet Protocol
IPv4 Address
IPv4 Address
Host name (Option 12)
Vendor Class ID (Option 60)
Important: The Priority goes as: Contact Ring Tone �� Account Ring Tone �� Default Ring
Tone.
Configures the number of custom ringtones to update in the provisioning process. The default
setting is 3. The valid range is 0 - 10.
Enable or disable multicast paging. The default setting is "No".
Allow Multicast Paging when DND mode is enabled.
Default Setting is "No".
During active call, if incoming multicast page is higher priority (1 being the highest) than this
value, the call will be held and multicast page will be played.
The default setting is "Disabled".
If enabled, during a multicast page if another multicast is received with higher priority (1
being the highest) that one will be played instead.
The default setting is "Enabled".
Multicast Channel Number (0-50). 0 for normal RTP packets, 1-50 for Polycom multicast
format packets.
The codec for sending multicast pages, there are 5 codecs could be used: PCMU, PCMA,
G.726-32, G.729A/B, G.722 (wide band), G.723.1.
Default setting is "G.722(wide band)".
Outgoing caller ID that displays to your page group recipients (for multicast channel 1 – 50).
Defines multicast listening addresses and labels. For example:
● "Listening Address" should match the sender's Value such as: "237.11.10.11:6767"
● "Label" could be the description you want to use.
For details, please check the "Multicast Paging User Guide" on our Website.
Table 16: Phone Settings Page Definitions
Network Settings �� Ethernet Settings
Selects "IPv4 Only", "IPv6 Only", "Both, prefer IPv4" or "Both, prefer IPv6". The default
setting is "IPv4 only".
Allows users to configure the appropriate network settings on the phone to obtain IPv4
address. Users could select "DHCP", "Static IP" or "PPPoE". By default, it is set to "DHCP".
Specifies the name of the client. This field is optional but may be required by Internet Service
Providers.
Used by clients and servers to exchange vendor class ID.