Phone Settings/Call Settings - Grandstream Networks GXV3380 Administration Manual

Phone Settings/Call Settings

Enable Video Call
Feature
Use Direct IP Call Mode
Use Paging Call Mode
Use Quick IP-Call mode
Enable Call Waiting
Enables Call Waiting
Tone
Enable DND Reminder
Ring
Enable Transfer
Hold Call Before
Completing Transfer
Default Transfer Mode
Enables the video call feature on the phone.
The default setting is "Yes".
Configures enable/disable direct IP call mode of the phone. If set to "Yes",
the feature of direct IP call will be enabled.
Default is "No".
Configures enable/disable paging call mode of the phone. If set to "Yes",
the feature of paging call will be enabled.
Default is "No".
Sets the phone system to automatically fills in the first three octets to make
an outbound IP call. If it is set to "Yes", users can dial an IP address under
the same LAN/VPN segment by entering the last octet in the IP address.
To dial quick IP call, offhook the phone, select IP call and dial XXX (X is 0-
9 and XXX <=255), the phone will make direct IP call to aaa.bbb.ccc.XXX
where aaa.bbb.ccc comes from the local IP address REGARDLESS of
subnet mask. XX or X are also valid so leading 0 is not required (but OK).
No SIP server is required to make quick IP call. The default setting is "No".
Enables the call waiting feature. If it is not checked, the phone system will
reject the second incoming call during an active session without user's
knowledge. But this missed call record will be saved to remind users.
The default setting is "Yes".
Sets the phone system to play the call waiting tone if there is another
incoming call. If it is set to "No", the phone will only display the indicator on
the LCD screen for another incoming call. The default setting is "Yes".
Configures the phone system to play the DND reminder ringtone for the
incoming call if the DND feature is enabled. If it set to "No", the phone will
keep mute instead of playing a ring splash to indicate an incoming call
when DND is enabled. The default setting is "Yes".
Enables the transfer feature. When set to "No", the phone system will block
the TRANSFER key on the LCD screen. The default setting is "Yes".
When set to "Yes" the phone holds the second call before completing the
attended transfer (it sends the INVITE method to hold the call before
sending the REFER method).
Sets the default transfer mode for the phone system. If the Blind Transfer
or Attended Transfer mode is set, the phone system will use the specific
mode to transfer an active call. The users still have privilege to switch the
mode on the LCD screen when they tap the transfer key.
The default setting is "Blind Transfer".
GXV3380 Administration Guide
Version 1.0.1.19
P a g e | 58