Table of Contents
Advertisement
INSTALLING YOUR PowerMate® LiftGate
F.
Secure the Base to the floor and the reinforcing steel with
3/8"-16NC Bolts, Washers and Lock Nuts.
STEP 3:
Running the wires
CAUTION!!
The best and easiest way to route the wire from the Unit to the
vehicle battery is to follow the path from the rear lights. If this is not
feasible you must avoid the following:
I.
Any heat sources. EG. Exhaust system.
II.
Any pinch points. EG. Suspension system.
III.
Any areas that may cause chaffing to occur on the wiring.
G.
The BLACK wire that exits the Base Assembly and is fed
through the floor must be fastened to a suitable Ground on
the vehicle frame.
H.
Slip a piece of Heat Shrink Tube over the RED wire.
I.
Connect the RED wire to the 6Ga. wire using the 6Ga.
Cable Splice and shrink the tubing over the connection.
J.
Provide a protective wire loom for the entire length of wire
installation including up through the floor into the Base
Assembly.
®
PowerMate
LiftGate™ Installation & Operation Manual
3.10
PN 018460 Rev.D2
Eng. 01/ 10/ 13
Hide quick links:
Advertisement
Table of Contents
