Processor Functions; Lamp; Brightness - Pentax EPK-700 Owner's Manual

RGB OUTPUT Y / C-OUTPUT Y / C-OUTPUT
RGB OUTPUT
VIDEO VIDEO
RS-232-C
CONTROL1 CONTROL2
KEY BOARD
LIFE METER

LAMP

BRIGHTNESS

COLOR BALANCE
+5
AUTO
SERVICE
MAN
0
BLUE
AVE
XLUM
CENT
-5
LAMP BRIGHTNESS COLOR BALANCE
+5
AUTO
SERVICE
MAN
0
BLUE
AVE
XLUM
CENT
-5
BREAKER (S) 2A
VIDEO PROCESSOR
MODEL EPKC-700P ASAHI OPTICAL CO., LTD.
INPUT XXXXXXXXX MADE IN JAPAN
SERIAL NO.
CONTROL
COPY
RED
FREEZE
CONTROL
COPY
RED
FREEZE
3. Use the Right or Left arrow keys to position the cursor under
the character to be corrected.
4. Characters can be typed over with alpha keys (including the
Space bar).
5. All fields can be edited/corrected except the Date and Clock.
See section 5-2, Setting the Date and Clock.
5-5

Processor functions

NOTE
Check the lamp life hour meter on the rear panel
frequently, a lamp with 200 hours or more should be
replaced before beginning a procedure.
5-5-1 Lamp
Turn on the power switch to light the lamp. If the lamp fails to
light, the lamp service LED lights. Turn off the processor, wait 60
seconds and turn on the processor. If the lamp still fails to light, do
not attempt to perform an endoscopic procedure. Contact your
local Pentax service center.
NOTE
After the lamp lights, allow the processor to run for ten
(10) minutes. This will allow the colour temperature to
stabilize and ensure accurate colour.
When the procedure is completed, the lamp can be switched OFF
by turning the EPK-700 power OFF. Wait 5 minutes before turning
on the Lamp again.
5-5-2 Brightness
Brightness functions can be controlled from either the processor
front panel control buttons or the endoscope control buttons. (See
section, Endoscope control buttons).
AUTO = Automatic brightness control, where the video signal of
the endoscope will automatically maintain the brightness level
selected by the brightness adjustment buttons. The switch will beep
when pressed and the AUTO indicator will light when the AUTO
mode is selected.
OPERATION
23