Table of Contents
Advertisement
RGB OUTPUT
Y / C-OUTPUT
Y / C-OUTPUT
RGB OUTPUT
BREAKER (S) 2A
VIDEO
VIDEO
VIDEO PROCESSOR
MODEL EPKC-700P
ASAHI OPTICAL CO., LTD.
RS-232-C
INPUT 100V~ 50-60Hz 1.8A
MADE IN JAPAN
CONTROL1
CONTROL2
SERIAL NO.
KEY BOARD
WARNING
LIFE METER
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,
REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE.
A / W
DRAIN
PREPARATION AND SAFETY CHECK
4
Preparation and safety
check
4-1
Preparation
4-1-1
Setting up the EPK-700
1.
Place the EPK-700 video processor on a stable, level surface
(trolley, bench, stand, etc. ...).
NOTE
• Avoid places where the EPK 700 may be splashed with
liquid.
• DO NOT use in any environment with explosive or
flammable gases.
• Do not block the venting louvres on the sides of the
video processor.
• When moving the EPK-700, do not hold the endoscope
locking lever.
2.
Make sure the power switch is OFF.
3.
Plug the power cord into the power source using the three-pin
plug supplied with the unit.
4.
Ensure the keyboard is properly connected.
CAUTION
To prevent electric shock, connect power cords of
ancillary equipment to medical isolating transformers.
NOTE
When using medical isolating transformers, be sure to
check that the total power consumption of all the devices
does not exceed the isolating transformers' power
ratings. Make sure that the power cord is connected to
the power line (vs) mains (8 rit) with a three-pin plug (In the
U.S.A. use UL2601-1 rated isolating transformers and/or
power strips only).
4-1-2
Connecting the water bottle
1.
Fill the water bottle approximately 2/3 full with sterile water.
2.
Screw the water bottle cap assembly firmly to the water bottle.
NOTE
Do not over tighten the water bottle cap
3.
Set the Air/Water-Drain lever to A/W.
4.
Insert the water bottle air-pipe stem into the EPK-700 water
bottle receptacle and press until the water bottle 'clicks' into
position.
15
Advertisement
Table of Contents
