Ford Mustang Shelby GT500 2020 Supplement Manual page 53

Rain Tray
E307009
The rain tray must be installed for
on-road driving.
Your vehicle comes with a removable rain
tray installed under the hood scoop.
Remove the rain tray for the following
reasons:
• For road course use.
• For cleaning.
E308574
To remove the rain tray:
Mustang (CZG) GT500, United States of America, Vehicles With: SVT Performance Package, enUSA, First-Printing
Track Use
1. Open the hood. See Opening and
Closing the Hood (page 38).
2. Partially remove the slotted T25 torx
fastener (C).
3. Remove the seven T25 torx fasteners
(B).
4. Slide the rain tray off of the slotted T25
torx fastener (C) and remove the rain
tray. The slotted fastener helps secure
the rain tray while you remove the other
fasteners.
5. Fully remove the slotted T25 torx
fastener (C).
Note: Use special care when removing the
fasteners so they do not fall into the engine
compartment.
To install the rain tray:
1. Align the rain tray with the alignment
posts (A) on the hood.
2. Partially install the slotted T25 torx
fastener (C) so that you can slide the
rain tray onto it. The slotted fastener
helps secure the rain tray while you
install the other fasteners.
3. Install the seven T25 torx fasteners (B).
4. Fully install the slotted T25 torx
fastener (C).
5. Close the hood. See Opening and
Closing the Hood (page 38).
Adjustable Rear Wing
The rear wing generates aerodynamic
down-force at speeds greater than 50 mph
(80 km/h).
Regularly inspect the rear wing panel and
attachment points for damage or
looseness.
You can adjust the wing using the hole
pattern at the top of the stanchion.
50