Table of Contents
Advertisement
To make sure that your tires perform as
intended, it is important that you maintain
your tires properly:
•
Your original equipment tires are
optimized for performance in both wet
and dry conditions. We do not
recommend using the original
equipment tires when temperatures
drop to about 45°F (7°C) or below
(depending on tire wear and
environmental conditions) or in snow
and ice conditions.
•
The tires were designed for track use
and may exhibit significantly reduced
tread life and increased tire noise
compared to the standard equipment
tires under normal driving conditions.
Increasing the front camber settings
beyond the factory settings may further
accelerate tread wear and induce tire
noise.
•
For tire pressures, see the placard
located on the B-pillar inside the driver
door.
•
Always maintain your tire pressures
according to the tire information
placard on the driver door jamb, using
an accurate gauge.
•
Tire pressures are specified cold and
should be checked after the vehicle has
been parked for at least three hours.
Do not reduce pressure of warm tires.
•
Check your tire pressure often to
maintain it properly. Tire pressure can
diminish over time and fluctuate with
temperature.
•
Do not overload your vehicle.
Maximum vehicle and axle weights are
listed on the tire information placard.
•
Extra caution should be taken when
operating the vehicle near its maximum
load, including assuring proper tire
pressure and reducing speeds.
Mustang (CZG) GT500, United States of America, Vehicles With: SVT Performance Package, enUSA, First-Printing
Wheels and Tires
•
•
•
•
•
•
E209823
59
Extra caution should be taken when
operating on rough roads to avoid
impacts that could cause tire damage.
In the event that you encounter an
abnormally harsh impact, inspect your
tires for damage.
Inspect your tires for damage on a
regular basis. If a tire is damaged,
replace it immediately.
Proper suspension alignment is critical
for maximum performance and
optimal tire wear. If you notice uneven
tire wear, have your alignment checked.
When replacing tires, the only way to
maintain original performance is to use
the original equipment tire. If a different
tire is used, it should be the same size,
speed rating and load rating and be
replaced as a set of four. Never mix tire
brands.
Rotate tires as recommended in the
tire rotation information. Your vehicle
has a staggered tire configuration.
Rotate the tires from side to side only,
not from front to back. See your
owner's manual for more information.
Hide quick links:
Advertisement
Table of Contents
