Table of Contents
Advertisement
WPS USER GUIDE
Inclinometer Assembly
Martin Audio supplies an optional remote angle monitoring system which can used to reliably check the angle at which the WPS array is
flown (relative to horizontal). It consists of a sensor (mounted within the flying frame) and a remote display unit. Interconnection is via a
standard XLR mic cable.
Fitting the inclinometer sensor to the flying frame
The WPS touring flying grid may be fitted with an inclinometer sensor which is available as an optional accessory part number ASM20017.
Once coupled with the ASM20019 inclinometer read-out display via a standard 3-pin XLR mic cable, precise measurements of the angle
of the array can be taken to ensure that the DISPLAY optimisation is as accurate as possible.
The touring flying frame part number WPSGRIDt has a mounting bracket with M4 threaded holes ready to accept the sensor.
The sensor is housed in a rugged weatherproof diecast aluminium enclosure. Fitting the sensor is a very quick and easy job requiring just
two tools, a 3mm Hex key (wrench) and a PZ2 Pozidrive screwdriver.
Remove the lid
The sensor is attached to the grid with two M4 cap head screws which must be inserted through pre-drilled holes in the box. To access the
M4 cap head screws it is necessary to remove the lid of the box.
Using the PZ2 Pozidrive screwdriver, unscrew all four lid screws until the lid can be removed from the base of the box. Note that the screws
do not have to be completely removed from the lid, they can remain captive in the lid to prevent them getting lost.
WPS USER GUIDE V1.0
24
Copyright © 2019 Martin Audio Ltd.
Advertisement
Table of Contents
