Selecting The Mode - Siemens SIMATIC VS130 Series Manual

Controlling with a PLC
Output Signals
Name
IN_OP
TRD
RDY
READ
MATCH
N_OK
6.1.2

Selecting the Mode

You can use the following modes:
•
Select code
•
Train code
•
Start evaluation
The modes are described in Section 5.3.
Select Code
To select a code, apply the appropriate bit pattern to the inputs SEL0 to SEL3. You
can select codes 1 to 15. If you select code 0, the last selected code is retained.
6-2
Function
In Operation:
•
0 = error message is displayed.
•
1 = SIMATIC VS 130 functional, no errors
Trained:
•
In Run:
0 = selected code has not been trained
-
1 = selected code has been trained
-
•
In Training (TRN=1):
0 = training active
-
1 = acknowledgment signal (RDY=0)
-
Ready:
•
0 = device startup or SIMATIC VS 130 in Stop
•
1 = SIMATIC VS 130 in Run
Result of evaluation: Code was localized and decoded.
Result of evaluation: Code matches learned code.
Code was not legible.
LED
Group error
SF on
SF off
TRAINED
READY
READ
MATCH
N_OK
Vision Sensor VS 130
A5E00199459-01