Warnings/Notes; Read Results - Siemens SIMATIC VS130 Series Manual

7.2.2

Warnings/Notes

Cons. Message Description
No.
This will This warning is displayed when the
1
delete all change you are planning will result
codes in all saved codes being deleted.
2 Can only You have attempted to select a
select code that has not been trained.
trained code
3 This will This message is displayed when
stop you change from the "RUN" menu
processing to the "STOP" menu.
7.2.3

Read Results

Cons. Message
No.
5HDG (55
1
:URQJ'0& 1.
2
0DWFK (55
3
Vision Sensor VS 130
A5E00199459-01
Description
The code could not be read in
the evaluation mode.
Note: You can modify this text in
Settings>Result>Messages
>ReadErr
The data matrix code
currently being read does
not correspond to the
expected data matrix code.
2. The parameter settings in
Settings>Result>Filter are
incorrect.
Note: You can modify this text in
Settings>Result>Messages
>FilterErr
The parameter selected in
Settings>Match was not found
in the data matrix code being
compared or the string defined
during training does not match
the current string of the data
matrix code.
Note: You can modify this text in
Settings>Result>Messages
>MatchErr
Possible Remedies
Check whether you really want to change
this parameter. If you do, all the saved codes
will be deleted and must be retrained.
Train the code. Afterwards, you can start the
evaluation.
Check whether or not you really want to
cancel the evaluation.
Possible Remedies
For possible causes, refer to "Error Training
Code" in the error messages.
1. Check whether the DMC currently being
read is correct.
2. Correct the settings in
Settings>Result>Filter.
1. The data matrix code currently being
read is different from the trained code
(and is therefore bad) or the wrong data
matrix code was trained.
2. Check the selected parameter settings
in Settings>Match.
Diagnostics
7-5