Unit Lighting - KBL megaSun 6900 Series Operating And Maintenance Manual

Hide thumbs Also See for megaSun 6900 Series:
Table of Contents

Advertisement

5.7

Unit lighting

Coloured fi lter
Replacing the
lighting system in
the lateral section
Step
1
Canopy:
Open the canopy pane and tilt it downwards.
2
Remove the tanning tubes 5 and 6. Now you can
replace the tube.
3
Re-install the tanning tubes and close the canopy.
4
Lateral pane:
Open the lateral pane and remove the two upper
tanning tubes. Now you can replace the tube.
5
Re-install the tanning tubes and close the lateral pane.
Replacing the
unit lighting in the
lower front section
Step
1
Undo the two screws of the base pane and tilt the
pane upwards.
2
Unscrew the protective conduit on both sides and
push it to the right (or to the left). Now you can replace
the tube.
3
Close the base pane.
24
Illustr. 5-14 Unit lighting in the lower front section and the starter for this tube on
the left side.
Operation and Service megaSun 6900
The coloured fi lter has to replaced at the latest when replacing
the tanning tubes.
Both in the canopy and in the lateral section, there is a coloured
lighting tube installed behind the tanning tubes. (see Table).
Procedure
The tube in the lower front section is located in a protective
conduit, which has been screwed onto the tube sockets. Take
the opportunity to check the filter mat and to clean or replace it if
necessary.
Procedure
Reference
Section 5.2
Section 5.2
Reference
Illustr. 5-14

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Megasun 6900 superMegasun 6900 super cpiMegasun 6900 super powerMegasun 6900 super power cpiMegasun 6900 ultraMegasun 6900 ultra power cpi

Table of Contents