Functions - KBL megaSun 6900 Series Operating And Maintenance Manual

4.2

Functions

Start
Stop
Running time
8
Operation and Service megaSun 6900
A function is switched on by pressing the plus sensor, which is
also used to increase the output stepwise. To set the maximum
value (e.g. fan speed) the sensor field has to be pressed again
and again until the maximum value has been reached.
A function is switched off by pressing the minus sensor, which
is also used to decrease the output step by step. To set the
minimum value (e.g. volume) the sensor field has to be pressed
again and again until the desired value has been reached.
You can use this touch key to switch on the apparatus during
the warm-up time.
If the tanning session has been interrupted by means of the
„Stop" key, it can be continued after touching the „Start" key
once again, provided the coin-operated counter has not run
down yet.
The numerical display shows the tanning time.
When the tanning time is over, the running text will appear
again.
By pressing this touch field for at least 2 seconds you can
terminate the tanning session prematurely.
During the tanning program the running time is displayed in this
field.
When adjusting the volume, the value set between 0 ... 99 % will
be displayed in this field for a short time.
When adjusting the fan speed, the value set between 20 ... 99
% will be displayed in this field for a short time.