Removing The Burners Of The Facial Tanners - KBL megaSun 6900 Series Operating And Maintenance Manual

5.5

Removing the burners of the facial tanners

Burners Only trained expert staff is allowed to install or remove burners.
Step
1 Remove the filter pane(s)
2 Hold the burners with a soft cloth in order to push them to
one side and then pull them out towards the front.
3 Do not touch the burner glass with your bare hands. If
necessary, you can clean the glass bulb with an alcoholic
cleaning agent.
Illustr. 5-12 Pushing the burner
sidewards
During service, dirt accumulation and an incorrect positioning
Installing the
may lead to damages of lamps and sockets. Therefore, when
burners
inserting the burners please make sure that the contact surfaces
of both sockets and burners are clean. Insert the burners in a
straight position into their sockets.
After being inserted into the socket, the little metal shackle in the
centre of the reflector should face the reflector.
Procedure
Illustr. 5-13 Pulling the burner out
towards the front
Operation and Service megaSun 6900
Reference
Section 5.3
Illustr. 5-12
Illustr. 5-13
21