Dismantling The Acrylic Panes - KBL megaSun 6900 Series Operating And Maintenance Manual

5.2

Dismantling the acrylic panes

Dismantling the
pane in canopy
and lateral part
Step
1 Fix the canopy.
2 Remove the screws and tilt down the canopy and/or
lateral pane(s).
3 When the pane is in the lower position, you can lift it out of
the swivel hinge support, if necessary.
4 Mount the pane in reverse order. Make sure that the frame
is correctly positioned in the hinge.
5 When closing the pane, all air nozzles must be matching
their counterparts. If not, carefully push the nozzles
concerned into their proper position.
6 Release the canopy.
Illustr. 5-2 Release the four screws
of the canopy pane
Base and duct
pane
16
Operation and Service megaSun 6900
The following tables explain how to dismantle the acrylic panes.
Procedure
The following table shows how to clean the base and duct pane.
The electronic parts installed underneath the bed must not get in
contact with any moisture.
Therefore, in order to clean the underside of the base pane and
the inner base section, use a slightly damp micro fibre cloth
only. You can also use it to clean the shoulder tanner. You can
use megaClean as a detergent (spray the cloth with it).
Illustr. 5-3 Release the four screws
of the lateral pane
Reference
10
Illustr. 5-2
Illustr. 5-3