Siemens SIMOTICS CONNECT 400 Operating Instructions Manual page 31

Result
The next step of the onboarding process is automatically performed. This procedure takes
about 1 minute. During this procedure, the "SIDRIVE IQ Config" application outputs messages
about the actions currently being performed. You receive confirmation once the onboarding
process has been successfully completed. The connectivity module starts to capture data, and
transfers this data at the preset intervals.
The connectivity module automatically starts the calibration procedure at the motor. It requires
10 measuring cycles with the motor in the RUN state and 10 measuring cycles with the motor
in the OFF state. Precise data is only displayed in the SIDRIVE IQ once the calibration
procedure has been completed.
● Value "0": Motor off (OFF), sensor calibrated
● Value "1": Motor state not defined, sensor not calibrated
● Value "3": Motor on (RUN), sensor calibrated
SIMOTICS CONNECT 400
Operating Instructions, 07/2019
6.7 Onboarding process using the "SIDRIVE IQ Config" application
Commissioning
29