Siemens SIMOTICS CONNECT 400 Operating Instructions Manual page 30

Commissioning
6.7 Onboarding process using the "SIDRIVE IQ Config" application
3. Select the operating mode: line operation: direct-on-line operation (DOL)
Note
Converter operation is not supported (VSD operation)
The actual version does not support motors controlled from a converter.
A dialog box to select the rated motor data opens. The electrical parameters saved in
SIDRIVE IQ are loaded to the connectivity module.
4. If there are several parameter sets in the rated motor data, select the parameter set that
corresponds to the connection conditions for your particular motor.
A dialog box to select the application opens.
5. Select the application.
28
SIMOTICS CONNECT 400
Operating Instructions, 07/2019