Siemens SIMOTICS CONNECT 400 Operating Instructions Manual page 21

"Device overview" page
When the "SIDRIVE IQ Config" application starts, as default, you see a list of all of the currently
visible assets on the "Device overview" page. You can also display all of the assets visible in
the history. A list entry contains the information about an asset. The following diagram explains
the pictograms in a list entry.
①
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪
SIMOTICS CONNECT 400
Operating Instructions, 07/2019
Motor symbol to identify an asset
You see all of the currently visible assets under this tab.
BLE name and Mac address of the currently selected connectivity module
Under this tab, you see all of the assets visible in the past.
Connection status of the connectivity module to SIDRIVE IQ (onboarding status)
● "Green" status: Connected
● "Orange" status: Not connected
● "Red" status: Connected, however, there is a connection error
Bluetooth interface signal strength display
WLAN configuration status of the connectivity module:
● "Green" status: WLAN configured and operating correctly
● "Red" status: WLAN not configured or has a fault
Battery state of the connectivity module (the current version does not support this display.)
"Connect" button to establish a connection to the connectivity module
Update status of the connectivity module firmware (the current version does not support this
display.)
Status of the connectivity module
6.3 Establishing the connection to the connectivity module
Commissioning
19