Step 7: Network Settings - Roland VersaUV LEF-12 First Step Manual

Before Using This Printer

STEP 7: Network Settings

Introduction
Make sure the machine is connected to the network by an Ethernet cable.
The network settings on the machine must be made manually, using the operation panel. For information
about how to make the settings, refer to "Make the Network Settings on the Printer" later in this step.
Also, to perform print from this machine, the software raster image processor (RIP) included with the machine
must be installed and set up. For information about installation and setup, refer to the documentation for
the software RIP.
This machine has a built-in print server as a network interface. When you use the print server, you can send
print data to the machine from anywhere on the network. TCP/IP is used as the protocol.
Important
The examples used in the procedures for making the settings described in this section assume you are
using one computer and one machine. The procedures and setting values described here may not be
suitable for all operating environments.
If the computer you're using is connected to a number of networked devices or to the Internet, incorrect
settings may adversely affect the entire network. For detailed information about the settings, consult
your network administrator.
Make the Network Settings for the Computer
Procedure

Log on to Windows as an "Administrator" or a member of the "Administrators" group.

Windows 10:
From the [Start] menu, click [Set], and then click [Network and Internet].
Click [Network and Sharing Center].
Click [Ethernet] or [Wi-Fi].
Windows 8.1:
From the [Start] menu, click [PC settings], and then click [Control Panel].
Click [Network and Internet], and then click [Network and Sharing Center].
Click [Ethernet] or [Wi-Fi].
Windows 7:
From the [Start] menu, click [Control Panel].
Click [Network and Internet], and then click [Network and Sharing Center].
Click the [Local Area Connection].
32