Roland VersaUV LEF-12 First Step Manual page 42

First Time Printing

Press
Move the print surface to a position 10 mm (0.39 in) away from the media gap sensor. This step can be
performed with the front cover open.
HEIGHT :

Press
Close the front cover when it is open.
Note: Check the height of the media again.
The following step moves the flat table rearward. Check again that the height of the media has been
adjusted so that the media does not come in contact with the media gap sensor. If the media hits the
media gap sensor, the media may be damaged or the head gap sensor may fail.
To re-adjust the height of the media, press

AUTO DETECTION
The flat table moves, and media height detection starts. The flat table lifts while moving backward and
forward until the media reaches a position where it comes in contact with the media gap sensor.
The media's height will be set automatically to a position 1 mm (0.04 in) away from the print head's ink
emission surface.
PRINT POS. TYPE
LOWER RIGHT
40
. mm
Media gap
sensor
.
Press
When the flat table stops moving, the screen shown on the left appears.
When one short beep is heard, the setup is complete.
to move the flat table.
10 mm
Media
again and redo steps from
.

.