How To Use Touch Pilot Control; User Interface; Connections; Touch Pilot Buttons - Carrier Touch Pilot Control Series Control Manual

5 - HOW TO USE TOUCH PILOT CONTROL

5.1 - User interface

Touch Pilot is a 7" colour touch screen with quick display of alarms,
current unit operating status, etc. It allows for web connectivity
and custom language support (control parameters displayed in
the language selected by the user).
This picture is for information only. It may differ from the actual look.
If the touch screen is not used for a long period of time,
the Welcome screen is displayed, and then it goes blank.
The control is always active and the operating mode remains
unchanged. Press anywhere on the screen and the Welcome
screen will be displayed.

5.3 - Touch Pilot buttons

Home button
Home screen displayed
Login button
Basic access
User access
Login screen
Login: Confirm advanced access login
Logout: Reset the user level access and go to the splash
screen
Force screen (override)
Set force: Override the current command (if possible)
Remove force: Remove the forced command

5.2 - Connections

Connections are located on the bottom side of the controller.
The controller comes with two RS485 ports, where the first port is
used to connect to Modbus and the second RS485 port is used
for internal communication. The Ethernet port allows for TCP/IP
communication or BMS (Building Management System) connection
thanks to BACnet/IP communication.
Legend
1. USB connector
2. Ethernet connector
3. Internal bus (RS485)
4. Internal bus (RS485)
5. Power supply connector (24 VAC)
Main Menu button
Main Menu displayed
Start/Stop button
Unit is stopped (grey icon)
Unit is running (green icon)
Save changes
Cancel your modifications
Displayed when the menu includes more than one page:
Go to the previous page
Displayed when the menu includes more than one page:
Go to the next page
(1) (2) (3) (4) (5)
Back button
Go back to the previous screen
Alarm button
No alarm active on the unit
Blinking icon: Partial alarm
(one compressor affected by the
existing alarm) or Alert (no action
taken on the unit),
Steady icon: Alarm(s) active on
the unit
Parameters screen(s)
Navigation buttons
9