Touch Pilot Control Interface; General Description; Screens Overview - Carrier 30XA Operation Instructions Manual

4 - TOUCH PILOT CONTROL INTERFACE

4.1 - General description

Touch Pilot includes the 5 in. touch screen allowing for easy
system control. Navigation through the Touch Pilot control is
either using the touch screen interface or by connecting to the
web interface. It is recommended to use a pen for the navigation
via the touch screen.
The navigation menus are the same for both connection
methods (Touch Pilot user interface and web browser). Only
two web connections are authorised at the same time.
NOTE: Some functionalities are unavailable when using the
web browser interface.

4.2 - Screens overview

The Touch Pilot control interface includes the following
screens:
• Welcome screen
• Synoptic screen
• Operating mode selection screen
•. Data/configuration.screens.
• Password entry and language selection screen
• Alarms screen
•. Parameter.modification.screen
• Time schedule screen
• Trending visualisation screen
If the interface is not used for a long period, the Welcome
screen is displayed, and then it goes blank. The control is
always active and the operating mode remains unchanged.
Press anywhere on the screen to access Touch Pilot control.
The Welcome screen will be displayed.
4.2.1 - Welcome Screen
The.Welcome.screen.is.the.first.screen.shown.after.starting.
the Touch Pilot user interface. It displays the application
name as well as the current software version number.
In order to exit the Welcome screen,
press the Home button
4.2.2 - Touch Pilot synoptic screen
The Synoptic screen provides an overview of the system control,
allowing the user to monitor the vapour-refrigeration cycle. The
diagram indicates the current status of the unit, giving
information on the unit capacity, the status of condenser and
evaporator.pump,.and.the.pre-defined.setpoint.parameter.
All unit functions can be accessed by pressing the Main menu
button
The bell located in the upper-right part of the screen lights
when any fault is detected (see also section 8.2).
By default, the parameters are presented in metric units. For
more information on how to change the system of
measurement, see section 4.3.3.
1. Economizer
2. Unit capacity percentage
3. Outdoor air temperature
4. Status screen message
5. Evaporator inlet and outlet water temperature
6. Setpoint
NOTE: The synoptic screen display may vary depending on
pumps configuration.
9