Power Cord Guidelines - Graco XM Series Operation Manual

Appendix C

Power Cord Guidelines

Use the guidelines listed in the following table to determine the power cord needed for your specific system.
XM_A (00, 11, 13,
21, 23, 30-32)
wall
Power Supply
N/A
Viscon HP Fluid
Heaters
Configuration Options:
1 A, 120 Vac
Controls
N/A
Viscon HP (2)
N/A
Hopper
Immersion
Heaters (2)
N/A
Viscon HP
with Heat
Circulation (1)
N/A
Electric Hose
Control (1)
❄ Full Load Peak 1 A
Amperes at 240 V,
1 Phase
2
Cord Specification AWG (mm ) at:
240 V, 1 PH
N/A
240 V, 3 PH
380 V, 3 PH
◆ Wired by user if ordered. Cord size determined by user.
❄ Full load amperes with all components operating at maximum capabilities. Fuse requirements for various flow
rates and heater temperature settings may be less.
312359J
Table 3: Power Cord Guidelines
XM_A (14-19,
24-29) XM_B (all)
wall wall; junction box
N/A 2 heaters
1 A, 120/240 Vac 1 A, 240 Vac
N/A 32 A at
240 Vac,
1 PH
13 A at 240 V, 13 A at 240 V,
1 PH 1 PH
16 A at 240 V, 16 A at 240 V,
1 PH◆ 1 PH
or or
15 A at 240 V, 15 A at 240 V,
1 PH◆ 1 PH
30 A 62 A
4 (21.2)
2 wire + ground
◆
6 (13.3)
3 wire + ground
6 (13.3)
4 wire + ground
XM_D (00, 11, 13,
XM_C (all) 21, 23, 30-32)
wall alternator
2 heaters N/A
1 A, 240 Vac N/A
32 A at N/A
240 Vac,
1 PH
13 A at 240 V, N/A
1 PH
N/A
16 A at 240 V,
1 PH ◆
or
15 A at 240 V,
1 PH ◆
N/A
62 A 0 A
(air only)
◆
N/A
Appendix C
XM_D (17, 19, 27,
29) XM_E (all)
alternator alternator
N/A 2 heaters
N/A N/A
N/A 32 A at 240 V,
1 PH (wired by
user with
explosion proof
methods)
N/A N/A
16 A at 240 V, 16 A at 240 V,
1 PH (wired by 1 PH (wired by
user with user with
explosion proof explosion proof
methods) methods)
N/A N/A
16 A 48 A
N/A N/A
79