Location; Grounding; Proper Lifting Of Sprayer - Graco XM Series Operation Manual

Location

XM sprayers are not approved for use in hazardous
locations unless the base model, all accessories, all
kits, and all wiring meet local, state, and national
codes. See ModelsModels, page 7, to determine the
appropriate location for your particular sprayer model.

Grounding

Connect the XM sprayer ground wire clamp (FG) to a
true earth ground. If wall power is used to power con-
trols or heaters, ground electrical connection properly
according to local codes.
312359J

Proper Lifting of Sprayer

Follow instructions to avoid serious injury or damage
to equipment. Never lift with the hopper(s) filled.
Drain all fluid prior to lifting sprayer.
Lift Using a Forklift
Power must be off. Sprayer can be raised and moved
using a forklift. Carefully lift the sprayer; make sure it
balances evenly.
Lift Using a Hoist
Sprayer can also be lifted and moved using a hoist. Con-
nect a bridle swing, hooking an end to each of the air
motor lift rings. Hook the center ring to a hoist. See the
following figure. Carefully lift the sprayer; make sure it
balances evenly.
FG
2.0 ft. (0.61 m)
minimum
ti21273a
NOTICE
ti21274a
Location
11