Configure To Supply Power - Graco XM Series Operation Manual

Setup

Configure to Supply Power

(Non-hazardous location sprayers only.)
NOTE:
Disregard terminal numbers on disconnect switch
blocks. Wire to positions shown.
1. Locate power jumpers.
TB2
Terminal Blocks
Position red jumpers
as shown
20
Power
Jumpers
ti18664a
380V 3ø WYE
(as shipped)
2. Use a flat-blade screwdriver to move red jumpers
from storage positions to positions for your power as
shown below. Push jumpers firmly into new position.
NOTE:
For 230V, 1 Phase and 230V, 3 Phase Installations,
change jumper positions as shown below. Machine is
shipped with jumpers in the fail-safe 380 3Ø position.
3. Close junction box cover.
230V 3ø Delta
230V 1ø
312359J