Models - Graco XM Series Operation Manual

Models

XM sprayers are not approved for use in hazardous
locations unless the base model, all accessories, all
kits, and all wiring meet local, state, and national
codes.
Check the identification plate (ID) for the 6-digit part number of the sprayer. Use the following matrix to define the
construction of the sprayer, based on the six digits. For example, Part XM1A00 represents an XM Plural-Component
sprayer (XM); 5200 psi pump set with pump filters (1); wall power supply, no heaters, no junction box, and is not
approved for hazardous areas (A); with no additional kits (00).
NOTE:
Some configurations in the following matrix cannot be built. Consult with distributor or Graco representative.
To order replacement parts, see Parts section the XM Plural-Component Sprayer Repair-Parts manual 313289. The
digits in the matrix do not correspond to the Ref. Nos. in the Parts drawings and lists.
XM
First and
Second
Digits
System Choice
(See Table 1 for lower models)
Pump Set
(hose/gun)
XM
(plural com-
1 5200 psi
ponent
sprayer
2 5200 psi
mounted
on a frame)
3 6300 psi
4 6300 psi
5 5200 psi
6 5200 psi
7 6300 psi
8 6300 psi
Location Category Key:
NE Not for use in explosive atmospheres.
EH For use in explosive atmospheres and hazardous
locations
.
312359J
1
Third Digit
Pump Remote
Filters Manifold
✔
A
B
✔
C
D
✔ ✔
E
✔
✔ ✔
✔
A
Fourth Digit
Kit Choice
Control Fluid Junction
Box Heaters Box
Wall Power
Supply
✔
Wall Power
Supply
✔
Wall Power
Supply
IS/
Alternator
✔
IS/
Alternator
Approvals
Location
(see page 8
Category
for approvals
CE, FM,
NE FM
c
✔
NE CE, FM,
FM
c
NE CE, FM,
FM
c
CE, FM,
EH FM Ex
c,
CE, FM,
EH FM Ex
c,
Models
00
Fifth and
Sixth
Digits
Additional
Kit
See Table
2 for
) selections
7