–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten the screws
evenly.
Guideline
C00860-01
Screw, handlebar
clamp
Info
The markings on the handlebar should be at the center
of the handlebar clamps.
Keep the gap widths equal when tightening.
–
Position the front fender and mount and tighten the screws.
Guideline
Remaining screws,
chassis
C00867-01
–
Release the axle clamp screws and remove the wheel spindle.
–
Install the front wheel.
M00696-01
–
Position the controls on the right half of the handlebar.
C00863-01
M8
20 Nm (14.8 lbf ft)
M6
10 Nm (7.4 lbf ft)
(
p. 16)
3 SETUP
7