Advertisement
3 SETUP
3.1
6
Unpacking and setting up the vehicle
C00858-10
402050-01
0 0
0 0
C00761-10
–
Remove the box and the plastic packaging.
Info
An assistant prevents the motorcycle from falling over.
To avoid damaging the motorcycle during the setup,
leave the protective film on the vehicle until you have
finished.
–
Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
–
To be in compliance with the homologation of the vehicle,
mount all of the parts in the separate enclosure when assem-
bling the vehicle.
Info
It is not necessary to mount all of the parts in the sepa-
rate enclosure for the vehicle to operate correctly. How-
ever, homologation will not apply if not all parts from
the separate enclosure are mounted.
–
Remove the KTM PowerPack.
–
Have a lift stand available.
Lift stand (78129955100)
–
Carefully loosen and remove the tension belt of the footrest
bracket.
Info
An assistant prevents the motorcycle from falling over.
–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
–
Remove screws
1
. Take off the handlebar clamps.
–
2
Remove screws
. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount
2
and tighten screws
.
Guideline
Screw, handle-
M10
bar support
Info
Position the left and right handlebar supports evenly.
(
p. 24)
40 Nm (29.5 lbf ft)
Loctite
®
243™
Advertisement
