Maintenance; These Are Maintenance Tasks That Should Be Performed By The User; Recommended Service Checking - Roland EGX-30 User Manual

9 Maintenance

These are maintenance tasks that should be performed by the user.

Cleaning the Unit
Use a vacuum cleaner to remove
cutting dust. Do not use any blower
like airbrush.
Otherwise, dust
spread in the air
may harm your
health or
damage this
machine.
NOTICE
When cleaning the EGX-30, make sure that the main unit's power OFF.
Use a dry cloth to clean the unit.
When engraving has been performed, use a whisk broom
or a vacuum cleaner to clean up any cuttings.
Replacing the Bearing for the Depth Regulator Nose (Option: DRN-20)
When engraving is performed, cuttings may get inside the bearing, resulting in a strange noise.
Because this can also degrade the quality of engraving, replacement of the bearing after every 100 hours of engraving is recom-
mended. (New bearings can be purchased from your vendor.)
How to Remove
the Bearing
Bearing for
Depth regulator nose

Recommended Service Checking

Please be aware that the following maintenance tasks are charged, even when performed within the unit's warranty period.
Replacement of spindle motor
The spindle motor is a part that will eventually wear out. After extended use, strange noises may be heard from the motor,
or the motor may fail to turn.
As a guideline, the spindle motor should be replaced after every 2000 hours of use.
Replacement of spindle belt
Like the motor, the belt is a part that wears out.
As a guideline, the spindle belt should be replaced after every 2000 hours of use.
24
How to Install
Screw on the bearing for the
the Bearing
depth regulator nose until
this space is approximately
3 mm (1/8 in.).
3 mm (1/8 in.)