If There's A Problem - Roland EGX-30 User Manual

10 If There's a Problem...

If operation of the EGX-30 becomes abnormal, immediately switch off the power to the unit.
No Power
Is the power cord plugged in correctly?
Make sure the power cord is plugged in securely.
Is the power switch set to ON?
Make sure the power is turned on.
No Operation When Commands Are Sent from the
Computer
Are the computer and the EGX-30 connected correctly?
Make sure the cable to the computer is securely connected.
Is the power switch set to ON?
Make sure the power is turned on.
Is the application software functioning correctly?
Check the state of the computer and software.
Are the computer (software) settings correct?
Refer to the documentation for the computer and software application to make the correct settings.
The Material Is Not Cut Correctly
Is the cutter broken?
Replace the cutter with a new one.
Are there any cuttings scraps adhering to the tip of the cutter?
Remove the cutter and wipe the tip with a soft cloth.
Is the right combination of tool and material being used?
Refer to "About Tools and Materials" and choose the appropriate tool for the material to be cut.
Has the correct cutting mode been selected?
Check the SELECT setting on the operation panel.
Is the material secured in place so that it will not move or come loose?
Refer to "Loading the Material" and use the appropriate method for the material type to secure the material in place.
Is the tool securely tightened so that it will not move or come loose?
Refer to "Installing a Tool" to install the tool securely.
Output Results Are Shifted from the Desired Location
Has the origin point been set correctly?
Refer to "Setting the Origin Point" to set the material's origin point correctly.
If the material has been changed, is it positioned differently than before?
Check the position where the material is loaded.
25