Installation And Connections; Installation; Connections - Roland EGX-30 User Manual

5 Installation and Connections

Installation

Install on a stable surface.
Failure to do so
may result in falling
of the unit, leading
to injury.
NOTICE
Never install this unit in any of the following situations, as it could result in damage:
Places where the installation surface is unstable or not level.
Places with excessive electrical noise.
Places with excessive humidity or dust.
Places with poor ventilation, because the EGX-30 generates considerable heat during operation.
Places with excessive vibration.
Places exposed to strong illumination or direct sunlight.
When arranging setup space for the EGX-30, make sure you have a space that is at least 800 mm (32 in.) wide, 800 mm (32 in.) in
depth, and 600 mm (24 in.) in height.

Connections

Do not use with a damaged power
cord or plug, or with a loose
electrical outlet.
Use with any other
power supply may
lead to fire or
electrocution.
NOTICE Always make sure that the power is off on both the computer and the EGX-30 whenever any cables are
connected or disconnected.
Securely connect the power cord, computer I/O cable and so on so that they will not be unplugged and cause
failure during operation.
Cables are available separately. One which you are sure matches the model of computer being used should be
selected.
Power cord
Rear View
Lock-use pins
Use either a parallel
cable or serial cable
to connect.
Parallel cable
(sold separately)
Serial (RS-232C) cable
(sold separately)
Screws
RS-232C connector
Screws
Printer connector
on the computer on the computer
11